Z-Board (EIFS) 60mm and 100mm

Our ZEGO Z-Board (EIFS) is an External Insulating Facade System which comes in your choice of 60mm or 100mm foam panels

  • Suitable for new homes up to Bushfire Attack Level BAL-19* first floor additions, alterations or renovation facades
  • Fire Rating in BAL-40 and BAL-FZ ( Flame Zone ) areas and walls on or within 900mm of a boundary use ZEGO FireFORM which also interlocks with the Z-Board and Domestic HomeFORMS
  • Fixed to timber or steel stud frame vertically at 300mm or horizontally at maximum 600mm centres
  • Self-supporting and interlocking
  • Also available in other thicknesses by request.
  • Easy to handle in windy conditions during installation
  • Apply Breathable Sarking or TYVEK Home wrap to frame
  • Large convection current grooves eliminates condensation
  • Fixed through to your structural timber or steel frame with only 9 fixings per square metre
  • No adhesives or battening required unless specified by the project designer ( built in convection grooves )
  • Thermally insulated and is a reflective barrier to sound absorption
  • External Finishes include but not limited to are Acrylic textured or smooth coloured render 8mm+2mm for Acrylic base and top coat renders, Stone – Stack stone, tiles, Alucabond, Batten and weatherboard, MiniOrb, ColorBond
  • * Up to BAL-19 ZEGO Z-Board walls to be rendered in Acrylic render e.g. Dulux Acra Tex 8mm polymer base coat with 160gram 4×4 or 5×5 fire retardant alkaline resistant render mesh in centre + Finish coloured smooth or textured top coat of 2mm minimum or 6mm Fibre Cement sheeting or Colourbond/Miniorb or Stone facing or Bushfire Resistant timber finishes
  • ZEGO Z-Board (EIFS) has a Design Registered Render Lock Dovetail Groove that mechanically locks the render to the ZEGO Flame Retardant INSUL8 “F” Grade EPS with self-extinguishing properties

Z-Board Usage Chart Z-Board Thicknesses R-Rating : approx 1.5 R per 50mm of insulation W28 W60 Z-Clips/m2
(300 vertical x 600 horizontal MAX)
Z-Screws required
(Hot dipped galvanized)
Used for cladding, insulating and providing a surface for render finish. Installed over timber frames, steel frames, brick, blockwork and concrete. Also for insulating Precast concrete panel buildings, existing buildings, gable ends, parapets & light weight upstairs extensions. 60mm 1.8R 9 per m2 100mm
100mm 3.0R 9 per m2 130mm
Render to CA26 compliance – up to wind load W60 – thickness 8mm base coat with reinforcement mesh plus finishing coat.

ZEGO Contact

ZEGO Pty Limited

Head Office & Tenders -- Ph (02) 9651 2277
GPO Box 4774
Sydney NSW 2001
Australia
quotes@zego.com.au
www.zego.com.au
Ph : 1300 13 9346
Fax : (02) 9651 2477

Get in Touch

To complete address details,Click here
To hide address details,Click here